Adaptec RAID 1430SA PCI-E

输入/输出 Adaptec, 调节器, IO, PCIe, Raid, SATA

Adaptec RAID 1430SA PCI-E
2 投票, 平均: 2.0 出最多 52 投票, 平均: 2.0 出最多 52 投票, 平均: 2.0 出最多 52 投票, 平均: 2.0 出最多 52 投票, 平均: 2.0 出最多 5
  ( 2 2 等级)

Adaptec RAID 1430SA PCI-E
Minimum: ¥ 500.00 
Maximum: ¥ 500.01  
更新: 04/07/2016 14:46


The Sata controller card “RAID 1430SA PCI-E” from Adaptec provides four SATA ports (2 internal, 2 external) and supports RAID-Level 0, 1, 10 and JBOD.

The card is limited to the so called Hostraid a.k.a. Fakeraid, which is not supported during the installation phase by most of the Linux distributions. If not supported there is a riks that the data on the raid partition will be destroyed during the installation phase, because e.g. if using Raid 1 both Raid partitions will become out of sync.

In general, it is not recommended to use Fakeraid hardware with Linux. Instead, the better supported software Raid of the Linux Kernel should be used.

If the PC is equipped with the Adaptec RAID 1420SA nonetheless, a Linux driver is provided by Adaptec at precompiled for SUSE, RedHat, or in source code.


scroll left scroll right


请使用注释部分提出更正的文章,以及相关的摘录 lspci -nnv, lsusb -v, lshw, dmesg ... 此外,使用一节的经验与此硬件组件或搜索该硬件的其他业主配置帮助交流。
Submitting comment...