AVM FRITZ Card PCI V2.0 (Internal ISDN Card)

VOIP / ISDN AVM, Fritz, ISDN, PCI

AVM FRITZ Card PCI V2.0 (Internal ISDN Card)
Linux compatibiliteit:
2 Beoordelingen, gemiddelde: 3,0 van de maximale 52 Beoordelingen, gemiddelde: 3,0 van de maximale 52 Beoordelingen, gemiddelde: 3,0 van de maximale 52 Beoordelingen, gemiddelde: 3,0 van de maximale 52 Beoordelingen, gemiddelde: 3,0 van de maximale 5
  ( 3 big 2 beoordelingen)

Categorie:


Linux compatibiliteit

The AVM Fritz PCI card exists in two version, v2.0 and v2.1. Both are supported by Linux, however, the installation and configuration effort can vary greatly depending on the distribution that is used. The support of ISDN cards is normally very good in SuSE distributions due to the large availability of ISDN in Germany. The AVM Fritz PCI card is supported by SuSE at least since SuSE 8 and can simply be configured with the SuSE configuration tool Yast.

The Installation and configuration unter Ubuntu is more complicated. First, the Linux kernel image has to be installed:

sudo apt-get install linux-image-386

Afterwards, a restart of the system is necessary before continuing with further installation steps.

The following packages have to be installed in a subsequent step:

sudo apt-get install linux-restricted-modules-386 libcapi20-dev libcapi20-3 capiutils pppdcapiplugin drdsl avm-fritz-firmware

The necessary Ubuntu conifugration of the card is described in detail at: http://wiki.ubuntuusers.de/AVM_Fritz!Card_DSL

AVM Fritz Karte PCI V2.0

The version V2.0 can be identified in the following way:

    29: PCI 104.0: 10300 ISDN Adapter
      [Created at pci.318]
      Unique ID: pe4v.12345678901
      Parent ID: RE4e.12345678901
      SysFS ID: /devices/pci0000:00/0000:00:08.0/0000:01:04.0
      SysFS BusID: 0000:01:04.0
      Hardware Class: isdn adapter
      Model: "AVM FRITZ!Card PCI v2.0"
      Vendor: pci 0x1244 "AVM GmbH"
      Device: pci 0x0e00 "Fritz!PCI v2.0 ISDN"
      SubVendor: pci 0x1244 "AVM GmbH"
      SubDevice: pci 0x0e00
      Revision: 0x01
      Driver: "fcpci"
      Driver Modules: "fcpci"
      Memory Range: 0xf9fffc00-0xf9fffc1f (rw,non-prefetchable)
      I/O Ports: 0xcc00-0xcc1f (rw)
      IRQ: 17 (no events)
      Requires: capi4linux, i4l-base, i4l-isdnlog
      Module Alias: "pci:v00001244d00000E00sv00001244sd00000E00bc02sc80i00"
      Driver Info #0:
        I4L Type: 8002/2 [AVM FRITZ!Card PCI v2.0]
      Driver Info #1:
        I4L Type: 1000/0 [AVM FRITZ!Card PCI v2.0]
      Config Status: cfg=no, avail=yes, need=no, active=unknown
      Attached to: #19 (PCI bridge)

or by lspci:

00:0b.0 Network controller: AVM GmbH Fritz!PCI v2.0 ISDN (rev 01)

that can also show

03:06.0 Network controller: AVM GmbH Fritz!PCI v2.0 ISDN (rev 02)

Linux information regarding the newer version v2.1 of the AVM Fritz card can be found at http://www.linux-hardware-guide.com/2013-07-31-avm-fritz-card-pci-v2-1-internal-isdn-card.


Vergelijkbare Linux hardware

scroll left scroll right

Reageren en beoordelen

Laat in de comments sectie beoordeling of commentaar en correcties op het artikel. Bijzonder nuttig zijn Ausz navigatie gebruik van ge lspci -nnk, lsusb, lshw, dmesg, enz, indien deze niet worden opgenomen in het artikel. Blijft het serveren. Het commentaar gebied van ervaringen tussen de eigenaars van de hardware-component en de Zoeken Configuratie Help Hotel
 
E-mailadres wordt niet gepubliceerd.
Submitting comment...