D-Link DGE-528T Gigabit Network Card

イーサネット イーサネット, Gigabit, ネットワーク, PCI

D-Link DGE-528T Gigabit Network Card
Linuxの互換性:
7 投票, 平均: 4.4 最大のうち 57 投票, 平均: 4.4 最大のうち 57 投票, 平均: 4.4 最大のうち 57 投票, 平均: 4.4 最大のうち 57 投票, 平均: 4.4 最大のうち 5
  ( 4.4 とともに 7 評価)



価格動向
D-Link DGE-528T Gigabit Network Card
-
Minimum: ¥ 0 
Maximum: ¥ 2,106  
更新: 19/05/2016 03:54

Linuxの互換性の検討

The Linux compatible Gigabit PCI network card D-Link DGE-528T (S/N: F3511B801084) has a very good price-performace ratio and is supported by Linux kernel Versions 2.4, 2.6 and 3.0 out-of-the-box. Furthermore, several cards can be used on one mainboard in parallel. Hence, the card is ideal for firewalls.

Before usage it should be verified that the mainboard supports the PCI 2.2 specification, because the card can not be used on older mainboards which only support PCI 2.1 (or lower).

The card is shipped with manual, driver software, low profile front panel and Wake-on-LAN cable:

The network card uses the Linux kernel module (e.g. Linux 2.6.48) r8169 and is initialized by the kernel in the following way:

 r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
 r8169 0000:04:01.0: found PCI INT A -> IRQ 5
 r8169 0000:04:01.0: (unregistered net_device): no PCI Express capability
 r8169 0000:04:01.0: eth0: RTL8169sb/8110sb at 0xf8018800, 84:c9:b2:43:09:fa, XID 10000000 IRQ 5

The DGE-528T has the PCI-ID 1186:4300, can be recognized by the following lspci output:

04:01.0 Ethernet controller: D-Link System Inc DGE-528T Gigabit Ethernet Adapter (rev 10)
Subsystem: D-Link System Inc DGE-528T Gigabit Ethernet Adapter
Kernel driver in use: r8169

and has the following characteristics:

 description: Ethernet interface
 product: DGE-528T Gigabit Ethernet Adapter
 vendor: D-Link System Inc
 version: 10
 size: 1Gbit/s
 capacity: 1Gbit/s
 width: 32 bits
 clock: 66MHz
 capabilities: pm bus_master cap_list rom ethernet physical tp mii 10bt 10bt-fd 100bt
                    100bt-fd 1000bt 1000bt-fd autonegotiation
 configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI
                       duplex=full ip=192.168.13.100 latency=64 link=yes maxlatency=64
                       mingnt=32 multicast=yes port=MII speed=1Gbit/s

同じようなLinuxのハードウェア

scroll left scroll right

注釈

記事の訂正を提出するだけでなく、の lspci -nnv, lsusb, lshw, dmesgなどの関連抜粋するコメントセクションを使用してください さらに、このハードウェアコンポーネントまたはこのハードウェアの他の所有者からの構成のヘルプを検索すると経験の交換のためのセクションを使用します。
 
メールアドレスが公開されることはありません。.
Submitting comment...