Hauppauge WinTV HVR-1700 DVB-T + Analogique PCI-E

Multimédia DVB-C, DVB-T, Hauppauge, PCIe, TV

Hauppauge WinTV HVR-1700 DVB-T + Analogique PCI-E
Examen de compatibilité avec Linux:
2 évaluations, en myoenne: 2,0 de 52 évaluations, en myoenne: 2,0 de 52 évaluations, en myoenne: 2,0 de 52 évaluations, en myoenne: 2,0 de 52 évaluations, en myoenne: 2,0 de 5
  ( 2 avec 2 évaluations)



courbe de prix
Hauppauge WinTV HVR-1700 DVB-T + Analogique PCI-E
-
Minimum: EUR 86,83 
Maximum: EUR 140,85  
Mis à jour: 09/03/2016 10:36

Examen de compatibilité avec Linux

The Hauppauge WinTV HVR-1700 (Model 81xxx) is a PCI-Express card equipped with a DVB-T and analog tuner. The card is partly supported since Ubuntu 11.04.
Warning: Only the DVB-T tuner is supported by Linux!

The card needs the firmware files dvb-fe-tda10048-1.0.fw, v4l-cx23885-avcore-01.fw and v4l-cx23885-enc.fw, which can be installed in Ubuntu by the package « linux-firmware-nonfree »:

sudo apt-get install linux-firmware-nonfree

Alternatively the firmware can be downloaded from http://steventoth.net/linux/hvr1700/.

The card gets recognized by the Linux kernel in the following way (source: http://www.linuxtv.org/wiki/index.php/Hauppauge_WinTV-HVR-1700):

cx23885 driver version 0.0.2 loaded
cx23885 0000:04:00.0: PCI INT A -> Link[LN2A] -> GSI 18 (level, low) -> IRQ 18
cx23885[0]/0: cx23885_dev_setup() Memory configured for PCIe bridge type 885
cx23885[0]/0: cx23885_init_tsport(portno=2)
CORE cx23885[0]: subsystem: 0070:8101, board: Hauppauge WinTV-HVR1700 [card=8,autodetected]
cx23885[0]/0: cx23885_pci_quirks()
cx23885[0]/0: cx23885_dev_setup() tuner_type = 0x0 tuner_addr = 0x0
cx23885[0]/0: cx23885_dev_setup() radio_type = 0x0 radio_addr = 0x0
cx23885[0]/0: cx23885_reset()
cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [VID A]
cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch2]
cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS1 B]
cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch4]
cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch5]
cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS2 C]
cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch7]
cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch8]
cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch9]
tveeprom 7-0050: Hauppauge model 81519, rev B2E9, serial# 6177447
tveeprom 7-0050: MAC address is 00-0D-FE-5E-42-A7
tveeprom 7-0050: tuner model is Philips 18271_8295 (idx 149, type 54)
tveeprom 7-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) ATSC/DVB Digital (eeprom 0xf4)
tveeprom 7-0050: audio processor is CX23885 (idx 39)
tveeprom 7-0050: decoder processor is CX23885 (idx 33)
tveeprom 7-0050: has no radio
cx23885[0]: hauppauge eeprom: model=81519
cx25840 9-0044: cx25  0-21 found @ 0x88 (cx23885[0])
cx25840 9-0044: firmware: requesting v4l-cx23885-avcore-01.fw
cx25840 9-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes)
cx23885_dvb_register() allocating 1 frontend(s)
cx23885[0]: cx23885 based dvb card
tda829x 8-0042: type set to tda8295
tda18271 8-0060: creating new instance
TDA18271HD/C1 detected @ 8-0060
DVB: registering new adapter (cx23885[0])
DVB: registering adapter 2 frontend 0 (NXP TDA10048HN DVB-T)...
cx23885_dev_checkrevision() Hardware revision = 0xb0
cx23885[0]/0: found at 0000:04:00.0, rev: 2, irq: 18, latency: 0, mmio: 0xfe800000
cx23885 0000:04:00.0: setting latency timer to 64

Matériel Linux Similaire

scroll left scroll right

Commentaires

Utilisez la section commentaires pour nous suggérer des corrections de l'article et des sorties de commandes lspci -vnn, lsusb, lshw, dmesg, etc...
De plus, vous pouvez utiliser les commentaires pour nous communiquer vos expériences avec le matériel ou pour rechercher de l'aide pour la configuration.
 
L'adresse email n'est pas rendue publique.
Submitting comment...