Adaptec RAID 1430SA PCI-E

I/O Adaptec, Controller, IO, PCIe, Raid, SATA

Adaptec RAID 1430SA PCI-E
Linux compatibility:
2 votes, average: 2.0 out of 52 votes, average: 2.0 out of 52 votes, average: 2.0 out of 52 votes, average: 2.0 out of 52 votes, average: 2.0 out of 5
  ( 2 with 2 ratings)

Price: CDN$ 465.00 (on stock)
(without shipping costs)

 Buy from Amazon.ca

Category:


Price trend
Adaptec RAID 1430SA PCI-E
-
Minimum: CDN$ 116.07 
Maximum: CDN$ 132.57  
Updated: 04/07/2016 14:45

Review of Linux Compatibility

The Sata controller card “RAID 1430SA PCI-E” from Adaptec provides four SATA ports (2 internal, 2 external) and supports RAID-Level 0, 1, 10 and JBOD.

The card is limited to the so called Hostraid a.k.a. Fakeraid, which is not supported during the installation phase by most of the Linux distributions. If not supported there is a riks that the data on the raid partition will be destroyed during the installation phase, because e.g. if using Raid 1 both Raid partitions will become out of sync.

In general, it is not recommended to use Fakeraid hardware with Linux. Instead, the better supported software Raid of the Linux Kernel should be used.

If the PC is equipped with the Adaptec RAID 1420SA nonetheless, a Linux driver is provided by Adaptec at http://www.adaptec.com/de-de/support/raid/sataii/aar-1430sa/ precompiled for SUSE, RedHat, or in source code.


Similar Linux Hardware

scroll left scroll right

Comments

Please use the comment section to submit corrections to the article as well as relevant excerpts of lspci, lsusb, lshw, dmesg e.t.c. Furthermore, use the section for the exchange of experiences with this hardware component or search for configuration help from other owners of this hardware.
 
Email address will not be published.
Submitting comment...