Everglide G-1000 (Gaming Mouse, USB, 1600dpi)

I/O Gaming Mouse, Mouse, USB

Everglide G-1000 (Gaming Mouse, USB, 1600dpi)
Linux compatibility:
1 vote, average: 4.0 out of 51 vote, average: 4.0 out of 51 vote, average: 4.0 out of 51 vote, average: 4.0 out of 51 vote, average: 4.0 out of 5
  ( 4 with 1 rating)


Review of Linux Compatibility

The Everglide G-1000 is a USB gaming mouse with USB ID 0957:0006

Bus 001 Device 002: ID 0957:0006 Agilent Technologies, Inc.

It is automatically recognized and fully supported by the Linux kernel:

usb 1-6: new low-speed USB device number 2 using xhci_hcd
usb 1-6: New USB device found, idVendor=0957, idProduct=0006
usb 1-6: New USB device strings: Mfr=1, Product=2, SerialNumber=0
usb 1-6: Product: ADNS-3080 Mouse
usb 1-6: Manufacturer: Agilent Mouse
usb 1-6: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes

Identified Hardware Configurations (1 Result)

This hardware component was used by Linux users under the following system configurations. These results were collected by our LHG Scan Tool:
Scan Date
Ubuntu 16.04.1 LTS 4.4.0-47-generic - 26/11/2016

Similar Linux Hardware

scroll left scroll right

 1 Comment

  • markus.enzenberger@___.com on said:

    I remember some problems I had with this mouse with an older motherboard on Ubuntu 12.04 that didn’t occur with Windows 7 on the same computer: if you didn’t move the mouse shortly after booting it would become disabled, I’m not sure if this problem was really Linux-related or an interaction with the USB support of the old motherboard because I haven’t encountered this problem after upgrading my motherboard.


Please use the comment section to submit corrections to the article as well as relevant excerpts of lspci, lsusb, lshw, dmesg e.t.c. Furthermore, use the section for the exchange of experiences with this hardware component or search for configuration help from other owners of this hardware.
Email address will not be published.
Submitting comment...