> Printer (229)
> Printer > All-in-One Printer (137)
> Printer > Laser Printer (83)
> Printer > Printserver (6)
Review of Linux Compatibility
The Canon Pixma MG7550 is an all-in-one color printer. The printer can be accessed via WiFi, Ethernet, and USB. It has the USB ID 04a9:177c:
Bus 001 Device 005: ID 04a9:177c Canon, Inc.
and is automatically recognized if connected via USB cable:
usb 1-1: USB disconnect, device number 2 usb 1-1: new high-speed USB device number 3 using xhci_hcd usb 1-1: New USB device found, idVendor=04a9, idProduct=177c usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-1: Product: MG7500 series usb 1-1: Manufacturer: Canon usb 1-1: SerialNumber: 44xxxx usblp 1-1:1.1: usblp0: USB Bidirectional printer dev 3 if 1 alt 0 proto 2 vid 0x04A9 pid 0x177C usbcore: registered new interface driver usblp
Furthermore, the integrated card reader is automatically supported under Linux:
usb-storage 1-1:1.2: USB Mass Storage device detected scsi host5: usb-storage 1-1:1.2 scsi 5:0:0:0: Direct-Access Canon MG7500 series 0201 PQ: 0 ANSI: 2 sd 5:0:0:0: Attached scsi generic sg3 type 0 sd 5:0:0:0: [sdc] Attached SCSI removable disk
The All-in-one printer was tested under Ubuntu 15.04 with a Linux kernel of version 3.19.0. The printer is automatically supported under Ubuntu 15.04 with the pre-installed generic printer driver. However, the scanner will not work out-of-the-box and needs the installation of the Linux Canon drivers, which can be downloaded at http://www.canon.se/support/consumer_products/products/fax__multifunctionals/inkjet/pixma_mg_series/pixma_mg7550.aspx.
Identified Hardware Configurations (1 Result)This hardware component was used by Linux users under the following system configurations. These results were collected by our LHG Scan Tool: