Inateck KTU3FR-4P (PCIe, 4 x USB 3.0)

I/O Inateck, PCI-Express, USB 3.0

Inateck KTU3FR-4P (PCIe, 4 x USB 3.0)
Linux compatibility:
7 votes, average: 5.0 out of 57 votes, average: 5.0 out of 57 votes, average: 5.0 out of 57 votes, average: 5.0 out of 57 votes, average: 5.0 out of 5
  ( 5 with 7 ratings)

Price: $ 20.00 (on stock)
(without shipping costs)

 Buy from Amazon.com

Category:


Price trend
Inateck KTU3FR-4P 
-
Minimum: $ 9.99 
Maximum: $ 23.99  
Updated: 11/04/2016 00:43

Review of Linux Compatibility

The Inateck KTU3FR-4P is a PCI Express card, which provides four USB 3.0 plugs. The card is supported under Linux, e.g., was successfully tested under Ubuntu 13.04 and Ubuntu 14.04.

The card is automatically recognized by the Linux kernel and has the PCI ID 1b73:1100

2:00.0 USB controller [0c03]: Fresco Logic Device [1b73:1100] (rev 01) (prog-if 30 [XHCI])
Subsystem: Fresco Lo Usage Type Data

The on-board USB hub has the USB ID 1d6b:0003

Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub

Identified Hardware Configurations (1 Result)

This hardware component was used by Linux users under the following system configurations. These results were collected by our LHG Scan Tool:
Distribution
Kernel
Rating
Scan Date
Fedora release 24 (Twenty Four) 4.5.0-302.fc24.x86_64 The user provided the following rating for this hardware: 5 out of 5The user provided the following rating for this hardware: 5 out of 5The user provided the following rating for this hardware: 5 out of 5The user provided the following rating for this hardware: 5 out of 5The user provided the following rating for this hardware: 5 out of 5 11/04/2016

Similar Linux Hardware

scroll left scroll right

 2 Comments

  • Peter Broadhurst on said:

    The 2-port (plus 20-pin) KTU3FR-202i variant worked perfectly for me with Ubuntu 14.10.

    lspci:
    2:00.0 USB controller [0c03]: Fresco Logic Device [1b73:1100] (rev 01) (prog-if 30 [XHCI])
    Subsystem: Fresco Lo Usage Type Data
    wMaxPacketSize 0×0004 1x 4 bytes
    bInterval 12
    bMaxBurst 0
    Hub Descriptor:
    bLength 12
    bDescriptorType 42
    nNbrPorts 4
    wHubCharacteristic 0x000a
    No power switching (usb 1.0)
    Per-port overcurrent protection
    bPwrOn2PwrGood 10 * 2 milli seconds
    bHubContrCurrent 0 milli Ampere
    bHubDecLat 0.0 micro seconds
    wHubDelay 0 nano seconds
    DeviceRemovable 0×00
    Hub Port Status:
    Port 1: 0000.02a0 5Gbps power Rx.Detect
    Port 2: 0000.02a0 5Gbps power Rx.Detect
    Port 3: 0000.02a0 5Gbps power Rx.Detect
    Port 4: 0000.02a0 5Gbps power Rx.Detect
    Binary Object Store Descriptor:
    bLength 5
    bDescriptorType 15
    wTotalLength 15
    bNumDeviceCaps 1
    SuperSpeed USB Device Capability:
    bLength 10
    bDescriptorType 16
    bDevCapabilityType 3
    bmAttributes 0×00
    wSpeedsSupported 0×0008
    Device can operate at SuperSpeed (5Gbps)
    bFunctionalitySupport 3
    Lowest fully-functional device speed is SuperSpeed (5Gbps)
    bU1DevExitLat 0 micro seconds
    bU2DevExitLat 0 micro seconds
    Device Status: 0×0001
    Self Powered
    gic Device [1b73:1100]
    Flags: bus master, fast devsel, latency 0, IRQ 17
    Memory at f7c00000 (64-bit, non-prefetchable) [size=64K]
    Memory at f7c11000 (64-bit, non-prefetchable) [size=4K]
    Memory at f7c10000 (64-bit, non-prefetchable) [size=4K]
    Capabilities: [40] Power Management version 3
    Capabilities: [50] MSI: Enable- Count=1/8 Maskable- 64bit+
    Capabilities: [70] Express Endpoint, MSI 00
    Capabilities: [b0] MSI-X: Enable+ Count=8 Masked-
    Capabilities: [100] Advanced Error Reporting
    Kernel driver in use: xhci_hcd

    lsusb:
    Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
    Device Descriptor:
    bLength 18
    bDescriptorType 1
    bcdUSB 3.00
    bDeviceClass 9 Hub
    bDeviceSubClass 0 Unused
    bDeviceProtocol 3
    bMaxPacketSize0 9
    idVendor 0x1d6b Linux Foundation
    idProduct 0×0003 3.0 root hub
    bcdDevice 3.16
    iManufacturer 3 Linux 3.16.0-25-generic xhci_hcd
    iProduct 2 xHCI Host Controller
    iSerial 1 0000:02:00.0
    bNumConfigurations 1
    Configuration Descriptor:
    bLength 9
    bDescriptorType 2
    wTotalLength 31
    bNumInterfaces 1
    bConfigurationValue 1
    iConfiguration 0
    bmAttributes 0xe0
    Self Powered
    Remote Wakeup
    MaxPower 0mA
    Interface Descriptor:
    bLength 9
    bDescriptorType 4
    bInterfaceNumber 0
    bAlternateSetting 0
    bNumEndpoints 1
    bInterfaceClass 9 Hub
    bInterfaceSubClass 0 Unused
    bInterfaceProtocol 0 Full speed (or root) hub
    iInterface 0
    Endpoint Descriptor:
    bLength 7
    bDescriptorType 5
    bEndpointAddress 0×81 EP 1 IN
    bmAttributes 3
    Transfer Type Interrupt
    Synch Type None
    Usage Type Data
    wMaxPacketSize 0×0004 1x 4 bytes
    bInterval 12
    bMaxBurst 0
    Hub Descriptor:
    bLength 12
    bDescriptorType 42
    nNbrPorts 4
    wHubCharacteristic 0x000a
    No power switching (usb 1.0)
    Per-port overcurrent protection
    bPwrOn2PwrGood 10 * 2 milli seconds
    bHubContrCurrent 0 milli Ampere
    bHubDecLat 0.0 micro seconds
    wHubDelay 0 nano seconds
    DeviceRemovable 0×00
    Hub Port Status:
    Port 1: 0000.02a0 5Gbps power Rx.Detect
    Port 2: 0000.02a0 5Gbps power Rx.Detect
    Port 3: 0000.02a0 5Gbps power Rx.Detect
    Port 4: 0000.02a0 5Gbps power Rx.Detect
    Binary Object Store Descriptor:
    bLength 5
    bDescriptorType 15
    wTotalLength 15
    bNumDeviceCaps 1
    SuperSpeed USB Device Capability:
    bLength 10
    bDescriptorType 16
    bDevCapabilityType 3
    bmAttributes 0×00
    wSpeedsSupported 0×0008
    Device can operate at SuperSpeed (5Gbps)
    bFunctionalitySupport 3
    Lowest fully-functional device speed is SuperSpeed (5Gbps)
    bU1DevExitLat 0 micro seconds
    bU2DevExitLat 0 micro seconds
    Device Status: 0×0001
    Self Powered

    dmesg:
    [ 0.616789] xhci_hcd 0000:02:00.0: xHCI Host Controller
    [ 0.616791] xhci_hcd 0000:02:00.0: new USB bus registered, assigned bus number 4
    [ 0.616817] usb usb4: New USB device found, idVendor=1d6b, idProduct=0003
    [ 0.616818] usb usb4: New USB device strings: Mfr=3, Product=2, SerialNumber=1
    [ 0.616819] usb usb4: Product: xHCI Host Controller
    [ 0.616821] usb usb4: Manufacturer: Linux 3.16.0-25-generic xhci_hcd
    [ 0.616822] usb usb4: SerialNumber: 0000:02:00.0
    [ 0.616954] hub 4-0:1.0: USB hub found
    [ 0.616966] hub 4-0:1.0: 4 ports detected

Comments

Please use the comment section to submit corrections to the article as well as relevant excerpts of lspci, lsusb, lshw, dmesg e.t.c. Furthermore, use the section for the exchange of experiences with this hardware component or search for configuration help from other owners of this hardware.
 
Email address will not be published.
Submitting comment...