Broadcom BCM5751 NetXtreme (PCIe, Gigabit Ethernet)

Ethernet Broadcom, Gigabit, Network card, PCI-Express

Broadcom BCM5751 NetXtreme (PCIe, Gigabit Ethernet)
Linux compatibility:
3 votes, average: 5.0 out of 53 votes, average: 5.0 out of 53 votes, average: 5.0 out of 53 votes, average: 5.0 out of 53 votes, average: 5.0 out of 5
  ( 5 with 3 ratings)

Price: $ 22.00 (on stock)
(without shipping costs)

 Buy from Amazon.com



Price trend
Broadcom BCM5751 NetXtreme 
-
Minimum: $ 19.99 
Maximum: $ 122.99  
Updated: 03/05/2016 23:16

Review of Linux Compatibility

The Broadcom BCM5751 Netxtreme is a PCI Express (v1.0a compatible) network card for Gigabit Ethernet. The card has the PCI ID 14e4:1677

02:00.0 Ethernet controller [0200]: Broadcom Corporation NetXtreme BCM5751 Gigabit Ethernet PCI Express [14e4:1677] (rev 01)

and is fully supported under Linux. The BCM5751 is accessed under Linux by the kernel module tg3 (at least since kernel version 3.110), which will be loaded automatically during booting:

PCI INT A -> GSI 16 (level, low) -> IRQ 16
setting latency timer to 64
eth0: Tigon3 [partno(BCM5751PKFBG) rev 4001] (PCI Express) MAC address 00:11:22:33:44:55
eth0: attached PHY is 5750 (10/100/1000Base-T Ethernet) (WireSpeed[1])
eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
eth0: dma_rwctrl[76180000] dma_mask[64-bit]
eth0: Link is up at 100 Mbps, full duplex
eth0: Flow control is off for TX and off for RX

Similar Linux Hardware

scroll left scroll right

Comments

Please use the comment section to submit corrections to the article as well as relevant excerpts of lspci, lsusb, lshw, dmesg e.t.c. Furthermore, use the section for the exchange of experiences with this hardware component or search for configuration help from other owners of this hardware.
 
Email address will not be published.
Submitting comment...